01/2007
9.2 ONLINE commissioning
9-245
© Siemens AG 2007 All Rights Reserved
SINUMERIK 840Di sl Manual (HBIsl) – 01/2007 Edition
Note
The stations accessible via the PG/PC interface are displayed in the
SIMATIC NET diagnostic screen.
Then click button: ”Next>”
Specify the online connection to the drive unit:
STARTER Project Wizard
Set
interface:
Change and test...
Continue >
Introduction
1.
Create a
new project
2.
Set PG/PC
interface
3.
Insert
drive
device
4.
Summary
Cancel
< Back
CP5611 (PROFIBUS)
4. Add the accessible SINAMICS drive units to the project.
The drive units found are displayed in the preview window. In the example, a
drive unit: ”Drive_Unit_Addr10” has been located.
Then click button: ”Next>”
Preview
STARTER Project Wizard
Refresh
view
Continue >
Introduction
1.
Create a
new project
2.
Set PG/PC
interface
3.
Insert
drive
device
4.
Summary
Cancel< Back
Project
Drive_Unit_Addr10
Note
Only Control Units are located when searching for SINAMICS drive units. All of
the other available components of a drive unit (infeed, motor module, etc.) are
not taken into account at this stage.
9 Drive Commissionin
SINAMICS
To Next Page
Loading...
