01/2007
1.2 Overview of software components
1-34
© Siemens AG 2007 All Rights Reserved
SINUMERIK 840Di sl Manual (HBIsl) – 01/2007 Edition
– SimoCom U
Commissioning tool for SIMODRIVE 611 universal/E and
SIMODRIVE POSMO SI, CD/CA drives
(installed and for installation: <CD path>\611utb\SimoComU\Setup.exe)
– SIMODRIVE 611 universal drive firmware
(firmware file: <CD path>\611utb\Sys611U\<version>\611u.ufw)
– SIMODRIVE 611 universal option module: ”Motion Control with
PROFIBUS DP” firmware
(firmware file: <CD path>\611utb\dpc31\<version>\v1sl.ufw)
– SIMODRIVE POSMO SI, CD/CA drive firmware
(firmware file: <CD path>\611utb\SysPosmo\<version>\posmo.ufw)
Note
SINAMICS drives
The commissioning tool: STARTER is not included in the SINUMERIK 840Di
scope of supply. The STARTER must be purchased separately.
References:
Catalog: NC 61 > SINAMICS S120 Drive System
The SIMATIC S7 add–on software contains sample programs and applications:
S PLC Toolbox
The PLC Toolbox contains the following components:
– PLC basic program
– SINUMERIK Add–On for STEP 7
e.g. SlaveOM for SINUMERIK 840Di sl, GSD file for PROFIBUS MCP
– NC variable selector
– PLC Symbol generator
(installation software: <CD path>\installs\add_on\plc_tb\setup.exe)
S GSD file for I/O modules PP72/48
Device master file with the required information in ASCII format required for
integration of the I/O module PP72/48 into a SIMATIC project as DP slave.
(DMF file: <CD path>\support\siem80a2.gsd)
S PLC application example
Sample application of a SIMATIC S7 project for SINUMERIK 840Di sl with
PROFIBUS machine control panel MCP 483 or MCP 310.
(ZIP file: <CD path>\support\840dismp\840disl_smpl.zip)
(archive file: <CD path>\support\840dismp\840disl_smpl.arc)
Note
The PLC Toolbox should be installed on the PG/PC on which the SIMATIC
STEP 7 is already installed.
SIMATIC S7
add–on software
1 General Information on the SINUMERIK 840Di sl
To Next Page
Loading...
