Siemens Sinumerik 840DiE sl - Page 382

01/2007
11.5 Axes and spindles
11-382
© Siemens AG 2007 All Rights Reserved
SINUMERIK 840Di sl Manual (HBIsl) – 01/2007 Edition
Axis–specific Signals from PLC to axis/spindle
31, ... 1.6 Position measuring system 2 A2
31, ... 1.5 Position measuring system 1 A2
31, ... 1.4 Followup mode A2
31, ... 1.3 Axis/spindle disable A2
31, ... 2.2 Spindle reset/delete distancetogo A2
31, ... 2.1 Controller enable A2
31, ... 3.6 Velocity/spindle speed limitation A3
31, ... 16.7 Delete S value
31, ... 16.5 Resynchronize spindle 2
31, ... 16.4 Resynchronize spindle 1
31, ... 16.3 Gear changed
31, ... 16.2–16.0 Actual gear stage A to C
31, ... 17.6 Invert M3/M4
31, ... 17.5 Resynchronize spindle during positioning 2
31, ... 17.4 Resynchronize spindle during positioning 1
31, ... 18.7 Direction of rotation setpoint left
31, ... 18.6 Direction of rotation setpoint right
31, ... 18.5 Reciprocating speed
31, ... 18.4 Oscillation via PLC
31, ... 19.7 – 19.0 Spindle offset H – A V1
Axis–specific Signals from axis/spindle to PLC
31, ... 60.7 Position reached with exact stop fine B1
31, ... 60.6 Position reached with exact stop coarse B1
31, ... 60.5 Referenced/synchronized 2 R1
31, ... 60.4 Referenced/synchronized 1 R1
31, ... 60.3 Encoder limit frequency exceeded 2 A3
31, ... 60.2 Encoder limit frequency exceeded 1 A3
31, ... 60.0 Axis/no spindle
31, ... 61.7 Current controller active A2
31, ... 61.6 Speed control loop active A2
31, ... 61.5 Position controller active A2
31, ... 61.4 Axis/spindle stationary (n < n
min
) A2
31, ... 82.3 Change gear stage
31, ... 82.2–82.0 Set gear stage AC
31, ... 83.7 Actual direction of rotation clockwise
31, ... 83.5 Spindle in setpoint range
31, ... 83.2 Setpoint speed increased
31, ... 83.1 Setpoint speed limited
31, ... 83.0 Speed limit exceeded
31, ... 84.7 Active spindle control mode
31, ... 84.6 Active spindle mode oscillation mode
31, ... 84.5 Active spindle positioning mode
31, ... 84.3 Rigid tapping active
31, ... 86 and 87 M function for spindle
31, ... 88–91 S function for spindle
11 NCK Commissionin
g
with HMI Advanced