Vista 5 M3 Digital Mixing System
4-96 GC Operation
Document generated: 28.08.13
SW V4.9
4.5.4.2 System Functions: Label Mode Selector
This icon allows the Label Mode for both Desk Labels and the Source/Target
Labels to be set at the same time.
Label Mode is toggled through to display:
Fixed Labels (labels created according to the currently active configuration)
User Labels (labels entered by the user in the General and Channel Patch)
Inherited/Device Labels (General Patch Source labels used on the control
surface).
Refer to chapter 4.3.3 for more information on Labels.
4.5.4.3 System Functions: The Surveyor
The Surveyor button keeps the operator informed about general system status.
The button’s icon changes to indicate the overall condition of the Vista. These
indications are as follows:
Yellow triangle: Loading. System is booting, look at the Status bar;
Green square: OK. Everything is fine;
Green square with yellow diamond: Not Found. A system element cannot be
found. This is sometimes seen when a configuration is loading. Otherwise it
may indicate a problem.
Red bullet: Error: Something is wrong. Open the Surveyor to see what is
malfunctioning.
Grey bullet: Not Used. A system element is defined but is not in use.
You can view more details about the system Status by clicking on the Surveyor
button, which will then open the Surveyor page.
Tip If you wish to determine which configuration is currently loaded, also click
on the Surveyor button. Other current system files (such as monitor files) may
be found within the Surveyor, but may be nested within subdirectories.
For more information on the Surveyor refer to chapter 4.8.
To Next Page
