Vista 5 M3 Digital Mixing System
5-100 AutoTouchPlus
Document generated: 28.08.13
SW V4.9
5.14.4 Isolate via Protection
Controls and the General Patch can be forced into ISOLATE using the Mix
Protection selection methods. This is different from selecting the ISOLATE
Control Mode in that Isolation persists only as long as the Protection Isola-
tion is applied. This provides a convenient method of temporarily Isolating
controls in any Mix Pass without creating new passes.
To apply Isolation via Protection, the same methods are used as when creat-
ing and applying Protection Sets. The only difference is ‘Isolate From Mix’
is checked for either Protection Sets, Global Patch, or both before Protection
is applied.
To Next Page
