Studer Vista 5 M3 - Isolate; Control Mode Entry

Vista 5 M3 Digital Mixing System
5-46 AutoTouchPlus
Document generated: 28.08.13
SW V4.9
Automation Menu • SelectingClear TRIM Replay Data from the Automation menu in the
GC deletes the fader Trim Replay Data and creates a new Mix Pass with
0 dB recorded as the new Trim Replay value.
Entering TRIM RECORD Controls in Trim Enable can change to Trim Record using any of the fol-
lowing methods:
• Local Touch (Touching the control on the Channel Strip) or CGM Touch.
TOUCH – Record engaged or the ISO (AUTO MODE) modifier key must
be used.
  • Global punch-in via GLOBAL RECORD
– Punch In button, or Auto-
Punch, or GPI (refer to chapter 5.9.5).
5.7.4 Isolate
Isolate is the system’s manual mode. Controls in Isolate neither respond
to or create new mix data. In other words, the control is essentially removed
from the automation system; it becomes strictly a manual control.
Note A control in Isolate mode differs from a Static control in regard that changes
in an Isolated control’s position are not written to Mix Passes. Likewise, Static
values are not applied to Isolated controls.
Isolate Rules Record Off:
  • Isolate: The control acts like a manual control and is unaffected by any
previously written Read and Trim Replay data.
- The audio follows the control position
Record On:
• AcontrolinIsolate cannot be placed into record.
5.7.5 Control Mode Entry
Controls may be put into the various Control Modes using different methods:
• Globally using the Global CONTROL MODES Activator buttons and
other controls in the ACU window.
• Locally using the channel strip ISO (AUTO MODE) key.
• When AutoTouchPlus is turned On using the Mix On button in the ACU
window (or the Mix On desk key). Activating the system will engage the
Control Mode selected in the Panel Presets Options page.
Note Multiple Control Modes may be active on the console simultaneously.