Studer Vista 5 M3 - Offline Editing Tutorial

Vista 5 M3 Digital Mixing System
AutoTouchPlus 5-133
Document generated: 28.08.13
SW V4.9
5.17.7 Offline Editing Tutorial
Select Objects 1. Click the ‘SELECT’ button in the AutoTouchPlus page in the GC.
2. Using the Object Picker, click the channel buttons to choose groups of
channels for editing.
3. Using the Object Picker, click the object buttons to choose groups of objects
for editing.
4. Click ‘Apply’ to select objects for editing.
OR
1. Click the ‘Show Channels>>’ button.
2. Check items in the Channel Tree to choose individual or groups of chan-
nels for editing.
3. Click the ‘Show Objects>>’ button.
4. Check items in the Object Tree to choose individual or groups of objects
for editing.
5. Click ‘Apply’ to select objects for editing.
Set an Edit Region 1. Click the ‘In’ button in the Active Mix box or enter a timecode address
manually.
2. Click the ‘Out’ button in the Active Mix box or enter a timecode address
manually.
3. Further manipulate the Edit Region as necessary.
Select an Edit Type 1. Using the Edit Type Menu, select the desired edit function.
2. Enter Set or Trim values if using those functions.
3. Enter the necessary timecode values as required by the selected Edit Type.
4. Click on the desired ‘At Out Time’ option.
Perform Edit 1. Click ‘Perform Edit’ to complete the process.
2. Repeat as needed.
After Editing In the mix pass tree, a new Mix Pass will be created after each ‘Perform Edit’
function.