Vista 5 M3 Digital Mixing System
5-60 AutoTouchPlus
Document generated: 28.08.13
SW V4.9
3c A control being in RECORD mode can be punched out by keeping the ISO
(AUTO MODE) key pressed, then touching and un-touching the control. At the
moment the control is released, it punches out of RECORD but remains in
HELD status.
Both Global TOUCH – Record and Global TOUCH – Hold active:
4a While keeping the ISO (AUTO MODE) key pressed, touching a control in
ENABLE mode will not PUNCH-INto RECORD. The control will remain
in HELD status.
4b A control being in RECORD status can be punched out by keeping the ISO
(AUTO MODE) key pressed, then touching and un-touching the control. At the
moment the control is released, it punches out of RECORD while remaining
in HELD status.
5.8.6.1.2 Option Modified Un-Touch Inverts <Touch Hold>
Both Global TOUCH – Record and TOUCH – Hold inactive:
5a While keeping the ISO (AUTO MODE) key pressed, touching a control in EN-
ABLE mode will switch it to RECORD and HELD status. When releasing
the control it will remain in RECORD and TOUCHED.
Global TOUCH – Record active, TOUCH – Hold inactive:
6a While keeping the ISO (AUTO MODE) key pressed, touching a control in EN-
ABLE mode will switch it to HELD but not to RECORD status, if the control
is released before the ISO (AUTO MODE) key.
6b While keeping a control in ENABLE mode touched, press the ISO (AUTO
MODE) key. Then release the control before releasing the ISO (AUTO MODE)
key, causing the control to switch to RECORD and HELD status.
Global TOUCH – Record inactive, TOUCH – Hold active:
7a While keeping the ISO (AUTO MODE) key pressed, touching a control in EN-
ABLE mode will switch it to RECORD but not to HELD mode, if the control
is released before the ISO (AUTO MODE) key.
Both Global TOUCH – Record and TOUCH – Hold active:
8a While keeping the ISO (AUTO MODE) key pressed, touching a control in EN-
ABLE mode will not punch the control into RECORD. When releasing the
control while the ISO (AUTO MODE) key is still pressed, the control will not
jump back to the replay value.
8b A control being in RECORD can be punched-out by pressing the ISO (AUTO
MODE) key, then touching the control and releasing it while the ISO (AUTO
MODE) key is still pressed. At the same time the control’s HELD status is
cleared.
To Next Page
