Vista 5 M3 Digital Mixing System
AutoTouchPlus 5-59
Document generated: 28.08.13
SW V4.9
Note To achieve the function mentioned above when Global TOUCH – Record
is inactive, the ‘Modified Untouch Inverts’ option (radio button TOUCH –
Record) must be selected (also refer to chapter 5.22.7).
5.8.6.1 Modified Un-touch Inverts
As an option, TOUCH – Record or TOUCH – Hold may have their modi-
fied Un-touch function inverted. In other words, if the ISO (AUTO MODE) key
is held down when a control is Un-touched (released) the normal Un-touch
function of TOUCH – Record or TOUCH – Hold will be reversed.
Either TOUCH – Record or TOUCH – Hold may be selected for Un-touch
inversion, but not both.
<Option> • EithertheTOUCH – Record or TOUCH – Hold function may be se-
lected for Modified Un-touch Inversion when the ISO (AUTO MODE) key
is held. This selection is made by clicking the desired radio button in the
<Modified Un-touch Inverts> section of the Misc Options page (also refer
to chapter 5.22.7).
5.8.6.1.1 Option Modified Un-Touch Inverts <Touch Record>
Both Global TOUCH – Record and Global TOUCH – Hold inactive:
1a Holding the ISO (AUTO MODE) key when an enabled control is touched, will
punch that control in RECORD. As long as the ISO (AUTO MODE) key is held
down, a touched control will be in RECORD. Un-touching the control will
return the status from RECORD to ENABLE.
1b If the control is touched and the ISO (AUTO MODE) key is released before the
control is physically un-touched, the control will remain in RECORD even
if the control is physically un-touched.
Even if the control remains in RECORD, the un-touch information is sup-
pressed.
1c A control being in RECORD can be punched out by holding the ISO (AUTO
MODE) key, and touching and un-touching the control while the ISO (AUTO
MODE) key is being pressed. The control changes from RECORD to ENABLE
when the control is physically un-touched.
Global TOUCH – Record active, Global TOUCH – Hold inactive:
2a While pressing the ISO (AUTO MODE) key, touching of a control that is in
ENABLE mode will not punch it into RECORD.
2b Touching the control (causing it to change from ENABLE to RECORD)
and pressing the ISO (AUTO MODE) key while still touching the control, then
releasing the control while still pressing the ISO (AUTO MODE) key will cause
the control to remain in RECORD and HELD status.
Global TOUCH – Record inactive, Global TOUCH – Hold active:
3a Keep the ISO (AUTO MODE) key pressed. Touching and untouching a control
in ENABLE mode will punch the control in and out of RECORD. Please
note that the control is in HELD status, regardless whether it is in RECORD
or not.
3b Keep the ISO (AUTO MODE) key pressed and touch a control that is currently in
ENABLE mode. Keep the control touched and release the ISO (AUTO MODE)
key. The control will remain in RECORD.
To Next Page
Loading...
