Studer Vista 5 M3 - SysAdmin: General Patch - ProBel Setup

Vista 5 M3 Digital Mixing System
4-130 GC Operation
Document generated: 28.08.13
SW V4.9
A Source or Target can be assigned to any of the Subclasses, but only to one
Subclass at a time.
To reassign an item or items from a Subclass, use the same selection tech-
niques as above. Then you can:
  • ClickontheClearSubclassbuttontoremovetheselecteditemsfromthe
Subclass. This will return the selected items to the Digital Input or Digital
Output Patch Section;
  • ClickonadifferentSubclassbuttontodirectlyre-assigntheselecteditems
from the current Subclass to another Subclass.
The result of this process is that the subclassified sections are now visible in
the Patch lists and can be directly accessed using the right touch pad button.
For details, refer to chapter 4.4.2.3.
Notes: Subclass names are saved and recalled with User Preferences.
Assignment of individual interfaces to subclasses is saved in each snapshot
preset and can therefor vary from snapshot to snapshot.
4.7.2 SysAdmin: General Patch – ProBel Setup
There is only one accessible item in this menu: Enable Probel Setup on Gen-
eral Patch.
4.7.2.1 3
rd
-Party Control of Console Patch (Native Pro-Bel P-02/08 Support)
Since version 3.5 of the Vista Software, these products are able to support
Pro-Bel enabled devices natively, and so a second PC is no more necessary for
this functionality. However, we do not recommend that existing installations
are altered that are already in use with a second PC for Pro-Bel interfacing.
The explanations below are therefore intended for installation personal and
not for the console operators.
Supported Functionality Our implementation enables the ability to map certain Pro-Bel connect
requests to a set of definable patch connections. The control of patch points
is not restricted to set output patch points. It is possible to set any patch points
within the console patch upon reception of a Pro-Bel command. The set-up
procedure is done from the General Patch screen, where certain patches can
be selected (by just selecting the affected targets) and which are being mapped
to a Pro-Bel source/destination combination with a single click on a dialog.