Studer Vista 5 M3 - Read

Vista 5 M3 Digital Mixing System
AutoTouchPlus 5-41
Document generated: 28.08.13
SW V4.9
5.7.1 Read
Read is the data replay mode of the system. Controls in Read mode will
playback changes written in the Mix Pass.
Read Rules Record Off:
  • REPLAY:Thecontrolplaysbackthemixdatatotimecode.
- Static controls will be set to the value stored within the Mix Pass.
(Static values are not timecode stamped.)
- Dynamic controls will be set to their stored values and subsequent
changes will be replayed.
  • AUDITION:Ifthecontrolismovedorpreventedfromfollowingwritten
changes, the audio changes to reflect the ‘audition’ level.
- When released the control will snap back to its written value
- A new Mix Pass is not generated when controls are auditioned.
Record On:
• AcontrolinRead cannot be placed into record.
Conditions • Iftouched,thecontrolwillenterAUDITIONforthedurationofthetouch.
When released (un-touched) the control snaps back to its written value.
• WithTOUCH – Hold engaged, the control will enter AUDITION when
touched and holds the audition value when released (un-touched).
<Option> • With<ReadSafe>checkedontheMisc.Optionspage,AUDITIONmode
is defeated for controls in Read and only written values will be heard.
Static Controls Changes may be made to Static controls while AutoTouchPlus is in Read (or
any other mode). Changes to Static values are temporarily stored in a global
memory buffer (Static Buffer). If a new Mix Pass isn’t written, changes to
Static controls will be retained in the buffer over time. For example, a section
of a song might be looped while adjustments to EQ, Pans, and other controls
are made. Changes to these Static controls will accumulate in the Static buffer
until a new Mix Pass is generated or the Static Buffer is cleared. The values
in the Static Buffer will saved as part of the next Mix Pass created.