Vista 5 M3 Digital Mixing System
AutoTouchPlus 5-11
Document generated: 28.08.13
SW V4.9
Hardware Keys The most important AutoTouchPlus commands have been assigned to the six
CUSTOM PANEL keys shown below.
Mix On Read
Write
Touch
Record
Touch
Hold
Clear
Touch
5.2.3 Mix Passes
Normally a new mix pass is automatically being created when play speed of
incoming timecode is detected. A mix pass finishes upon detection of non-
play speed.
In order to record slower than play speed (slow motion) or even write auto-
mation data between two locate points, it is necessary to start and stop a mix
pass manually.
A mix pass is manually started by switching Stop Frame automation on by
using the Stop Frame button. It is finished when this button is switched to
off again.
Note: The automation cannot record backwards; it records data up to any incre-
mented timecode value. Therefore it is not possible to erase data by going
backwards using the transport buttons on the Machine Control window.
To Next Page
