Vista 5 M3 Digital Mixing System
4-150 GC Operation
Document generated: 28.08.13
SW V4.9
Option to bring back ALT N–X status upon closing fader.
Option active (): The signal will switch back to ALT N–X upon closing
the fader again, in case it was active before opening. This allows e.g. feeding
an off-air signal to the outside lines while there are not on air (e.g. output
signal from on-air console including commercials). Result: When the fader
is opened, the outside lines get the normal N–X signal; when closed they are
switched to the off-air signal.
Option inactive (original behavior): If the ALT N-X key (i.e. USR 1 or USR 2
key defined above) was active and the fader was opened, the return signal
would automatically switch to normal N–X. After the fader is closed again,
the signal would stay on N–X.
To Next Page
