Studer Vista 5 M3 - Page 449

Vista 5 M3 Digital Mixing System
AutoTouchPlus 5-153
Document generated: 28.08.13
SW V4.9
Write to... Punch-Out The Punch-Out glide will take place if the control is punched out…
  • Whiletimecodeisrunning(glidetakesplaceinreal-time)
  • AsaresultofTimecodebeingstopped(glidetakesplaceinthepostpro-
cess)
  • Andeveniftimecodeisstoppedinthemiddleoftheglide(glidetakes
place partly in real-time and partly in the post process). This is a great
feature because there are many times when a machine (TC) is stopped by
one mixer just after another mixer has punched out and a glide has begun.
In this case the glide will occur unscathed.
Write to... Next Change When an old Read Mix data record is encountered for this control, a glide
begins at that point and extends for the duration of the glide time (of course
this assumes that the option is set and that the ACU Glide button is active
at the time of the next change).
Write to... End When the end time occurs (either in real time or as part of the post process-
ing) a glide begins. The glide starts at the end time if set to End of Mix or
a Fixed timecode. If the glide takes place during the post process (after the
mix pass is ended) then the ACU Glide button must be active at the time the
Mix pass is stopped. If End is set to End Of Time, no glide occurs. (Also see
Back Time Glide option below.)
Write to... Write Zone End If the Write Zone is active then a glide will occur at the Write Zone End
time either in real time or as part of the post process (subject to the state of
the option and the ACU Glide button. (Also see Back Time Glide option
below.)
Extend Back To: Begin If Extend Back To: Begin is active, then a glide will occur at the Begin time
(beginning of Mix or a user-input TC) as part of the post processing (subject
to the state of the option and the ACU Glide button)
Extend Back To: Punch-In If Extend Back To: Punch-In is active, then a glide will occur at the Punch-
in time as part of the post processing (subject to the state of the option and
the ACU Glide button at the time of Punch-in).
Back Time Glide (applies to End and Write Zone End only)
If this option is set, then the glide will begin such that the glide ends at the
End or Write Zone End time rather than beginning at that time. This back-
times the glide so the data beyond the end time (or write zone end time) is
perfectly preserved and match before the transition point.