Event Messages
258 SSU-2000 User’s Guide 12713020-002-2 Revision D – April 2004
Port, Dis, COML\ 199 User Enabled | Disabled input port
SSM, Auto, COML\ 200 User changed SSM setup
Priority, 5, COML\ 201 User changed input priority level
SSM Bit, 4, COML\ 202 User changed SSM Bit location (E1 only)
Prov PQL, 5, COML\ 203 User changed input provisioned PQL
MTIE, T100, L1, 550, COML\ 204 User changed input MTIE limits (L1 | L2)
Gain, On, COML\ 205 User changed the input gain control
CSFlt, Off, COML\ 206 User changed input Cesium Fault control
Err Cnt, BPV, 16, COML\ 207 Signal Alarm Error Count (LOS, AIS, OOF,
BPV, or CRC)
Clr Cnt, OOF, 5, COML\ 208 Current Signal Alarm Clear Count (LOS,
AIS, OOF, BPV, or CRC)
Freq Err Limit, Clk-A, 100 209 The frequency error limit settings have been
changed
Freq Clr Limit, Clk-A, 800 210 The frequency clear limit settings have been
changed
MTIE Clr Limit, T100, L1, 500, COML\ 211 The MTIE error limit settings have been
changed
MTIE Limit, DS1, COML, Setting 212 The MTIE clear limit settings have been
changed
PBO, Report, COML\
(Disable|Event|Report|None)
213 Phase Build-out system response has been
changed to the indicated setting
Freq Tau, Clk-A, 400, COML\ 214 The frequency TAU limits have been set
Err Delay, (0), 10 sec, COML\ 251 An alarm delay time change
Alm Level, (2), Maj, COML\ 252 An alarm level change
Elevate Time, 86400 sec, COML\ 253 An alarm elevation time change
Setup, Save, COML\ 254 User defaults have been set and saved
GPS Input Module Events
Install, GPS/CDMA Module\ 129 Module Installation
Remove, GPS/CDMA Module\ 130 Module Removal
Enable, GPS/CDMA Module\ 131 The input module has been enabled
Disable, GPS/CDMA Module\ 132 The input module has been disabled
Table A-8. Input Module Event Messages (Continued)
Event Message Event # Event Description
To Next Page
Loading...
Need help?
General
