TL1 Command Interface
312 SSU-2000 User’s Guide 12713020-002-2 Revision D – April 2004
SET-PRMTR-SNMP-MANAGER:[tid]
::ctag::mode,[ip];
Valid aid code: none
This command allows changes to the SNMP manager table
entries.
mode = {ADD| DEL| INIT}
where:
ADD requires an IP address
DEL only requires an IP address to delete the entry from
the table
INIT requires no additional parameters and clears all
entries in the table
SET-PRMTR-SNMP-USER:[tid]::
ctag::mode,[rd_community],
[wr_community], [level];
Valid aid code: none
This command allows changes to the SNMP security of the
system.
mode = {ADD| DEL| MOD| INIT}
where:
ADD requires a rd_community and wr_community
Level defaults to 1 if not entered
DEL only requires a username to delete the user from the
table
MOD requires a username, a new password, and new user
level
INIT requires no additional parmeters and clears all
entries in the table
SET-PRMTR-SNMPV3-MANAGER:
[tid]::ctag::mode,[ip],
[username];
Valid aid code: none
This command allows changes to the SNMPv3 manager table
entries.
mode = {ADD|DEL|MOD|INIT}
where:
ADD requires an IP address and username
DEL requires an IP address to delete the entry from the
table
DEL requires an IP address to key the entry and modify its
username in the table
INIT requires no additional parameters and clears all
entries in the table
SET-PRMTR-SNMPV3-
NOTIFICATION:[tid]::ctag::
[notification];
Valid aid code: none
This command sets the SNMP v3 notification type.
notification = {V2|V3|ALL} to set SNMP notification to
SNMPv2, SNMPv3, or both types when an event occurs
Table B-6. TL1 Set Commands (Continued)
Command Description
To Next Page
Loading...
Need help?
General
