12713020-002-2 Revision D – April 2004 SSU-2000 User’s Guide 345
Interactive Command Set
SSM {4|5|6|7|8} Sets the E1 SSM bit position
PQL {2|3|4|5|6|8} Sets the Priority Quality Level (PQL) for the
specified input port
MTIE [{EL1|EL2|CL1|CL2}]{T10|T100|T1K|T10K|T100K}
value
Sets MTIE Limit 1 or Limit 2 for 10/100/1,000/
10,000/100,000 seconds threshold. If L1 or L2 are not
provided, both limits are implied. The Limit Range is [0
– 100,000].
EL1 MTIE Error Limit 1
EL2 MTIE Error Limit 2
CL1 MTIE Clear Limit 1
CL2 MTIE Clear Limit 2
T10 MTIE 10-second period
T100 MTIE 100-second period
T1K MTIE 1000-second period
T10K MTIE 10000-second period
T100K MTIE 100000-second period
MTIE {PRS|DS1|G.811|G.823}
Sets MTIE Limit 1 or Limit 2 for predefined values
ANSI Specification –
PRS, DS1
ITU Specification – G.811, G.823
GAIN{ON|OFF}
Enables or disables input gain setting for port one
CSFLT {HIGH|LOW|OFF} Sets cesium fault logic level
HIGH
Alarm active when the fault is a high logic level.
LOW
Alarm active when the fault is a low logic level.
OFF
Default. Cesium Fault is ignored (not the AIS).
{AIS|BPV|CRC|LOS|OOF}{SET|CLR} value
Sets Error Count (SET) or sets Clear Count (CLR) of
the specified input hardware alarm signal. Range is 1 to
100.
FREQ {A|B}{SET|CLR|TAU} value
Sets Frequency limits on Clock A or Clock B
SET Sets Frequency Error Count
CLR Sets Frequency Clear Count
TAU Set frequency tau (default is 400), range is
10 to 1000
Level 4 Same as Level 3 operation
Remarks None
Related REF, SETUP, STATUS
Restrictions None
To Next Page
Loading...
Need help?
General
