Interactive Command Set
352 SSU-2000 User’s Guide 12713020-002-2 Revision D – April 2004
MTIE
Use this command to display the MTIE data from a selected input port.
Level 0 Not applicable
Level 1
MTIE xAy-z [{A|B}] startdate [starttime][stopdate
[stoptime]]
MTIE xAy-z [{A|B}] starttime [stopdate][stoptime]
MTIE xAy-z [{A|B}] HISTORY [count]
Options are:
A| B CLK A or CLK B; the default is the selected clock
output.
starttime Specifies the start time of a specific period of time to be
displayed.
stopdate Specifies the date ending a specific period of time to be
displayed.
stoptime Specifies the stop time of a specific period of time to be
displayed.
If the starttime, stopdate, and stoptime are not
specified, the system defaults to a 24 hour period.
HISTORY [count]
Displays the one-day MTIE history for the last number
of days specified in the count parameter.
This command displays the MTIE information calculated on the
input module with a specified clock. A start time and stop time are
required to perform an MTIE calculation. If these are not specified
in the command line, the start time defaults to the last 24 hours,
the stop time defaults to the current time.
Note: If you specify times and dates, the MTIE that occurred after the
starting date and time and before the ending date and time displays.
Specified dates have the format yyyy-mm-dd, and specified times
have the format hh:mm:ss. Specified dates and times are not
provided in ISO timestamp format, and must be separated by a
space. Starttime and stoptime both default to the current time of day.
Stopdate defaults to the current date. Startdate defaults to the current
date, minus 24 hours.
To Next Page
Loading...
Need help?
General
