12713020-002-2 Revision D – April 2004 SSU-2000 User’s Guide 359
Interactive Command Set
PBO
Use this command to gain access to the phase buildout (PBO) in the input module.
Level 0: NA
Level 1: PBO
Display the PBO current mode from each input
Level 2: Same as Level 2 operation.
Level 3:
PBO [DISABLE|REPORT|EVENT|NONE]
Options are:
DISABLE PBO disabled
REPORT PBO Enabled, the PBO events sent out and displayed,
but not stored in the COMM event buffer
EVENT PBO Enabled, the PBO events sent out and displayed,
but not stored in the COMM event buffer
NONE PBO Enabled, but no PBO events displayed
Level 4: Same as level 3 operation
Remarks: None
Related: INPUT, PHASE
Restrictions: None
To Next Page
Loading...
Need help?
General
