Interactive Command Set
366 SSU-2000 User’s Guide 12713020-002-2 Revision D – April 2004
RESET
Use this command to reset the clock module through the Comm Module.
Level 0: NA
Level 1: NA
Level 2: NA
Level 3:
RESET {xAy}
Resets the specified clock module. It must have an operand to
indicate Clock A or Clock B. Any other operand is invalid. This
command requires the whole entry ‘RESET’ be entered to verify
that the user really wants to restart that module. This command
requires a confirmation (YES|NO). If confirmation failed, no action
occurs.
Level 4: Same as level 3 operation
Remarks: None
Related: RESTART
Restrictions: This command uses the COMM module PLD’s CLK A/B reset bit to
reset the clock module. The software is required to hold the
RESET bit for at least for 4 seconds and then writes a zero for that
RESET bit.
To Next Page
Loading...
Need help?
General
