12713020-002-2 Revision D – April 2004 SSU-2000 User’s Guide 367
Interactive Command Set
RESTART
Use this command to restart the software for a specified module.
Level 0 Not applicable
Level 1 Not applicable
Level 2 Not applicable
Level 3
RESTART [xAy]
Use this command to restart the module. If you do not provide a
parameter, the command refers to the Communications Module.
This command requires the whole entry RESTART to be entered to
verify that you want to restart the module. This command requires
a confirmation (YES|NO). If confirmation fails, no action is required.
Level 4 Same as Level 3 operation
Remarks None
Related None
Restrictions This command is based on the target module. It has the SPI
software RESTART command support. This command assumes
that the target module is working properly. If the target module
does not work, this command has no effect.
To Next Page
Loading...
Need help?
General
