Interactive Command Set
370 SSU-2000 User’s Guide 12713020-002-2 Revision D – April 2004
SNMP
Use this command to provide access to SNMP user list and provide the SNMP
manager IP addresses.
Level 0: NA
Level 1:
SNMP [USER|MANAGER]
If this command is used with any operand, it will display the valid
SNMP user names and their associated access levels. It also
displays the SNMP enabled/disabled mode, and SNMP manager
IP addresses.
Options are:
USER Displays the valid SNMP user names and their
associated access levels
MANAGER Displays the SNMP manager table contents
Level 2: Same as level 1 operation
Level 3: Same as level 2 operation, with the following additions:
SNMP [DISABLE|ENABLE]
SNMP TRAP {ALARM|ALL}
Options are:
DISABLE Disables the SNMP agent
ENABLE Enables the SNMP agent and allow MIB manager to
see the view
TRAP Allows user set filter for SNMP trap (event port)
ALARM Only Alarm Traps sent out
ALL All Traps sent out
Level 4: Same as level 3 operation, with the following additions:
SNMP USER [{INIT|ADD|MODIFY|DELETE}]
SNMP MANAGER [INIT|{ADD|DELETE}] [ip_address]
Options are:
USER SNMP User Table
INIT Clears the whole SNMP user table and only leaves the
built-in users in the systems. This option clears the
table.
To Next Page
Loading...
Need help?
General
