12713020-002-2 Revision D – April 2004 SSU-2000 User’s Guide 371
Interactive Command Set
ADD Adds the SNMP user “read community” to the system. If
the user exists in the system this option exits with an
error. After the read community string is entered, this
command prompts for a write community. Write
Community entries are echoed as ‘*’. Valid write
community characters are all upper alphanumerical
characters. After the write community string is entered,
this command prompts for the user level.
MODIFY Modifies the write community and/or the access level
for the given user. If the user id is not in the system, this
command exits with an error. Once the user is entered,
this option performs identically to the ‘ADD’ option.
DELETE Deletes the user from system. If the user id is not in the
system, this command exits with an error.
Note:
MANAGER SNMP Manager Table
INIT Initializes the SNMP Manager Table to all null IP
address
ADD Adds an SNMP Manager IP address into the SNMP
Manager Table
DELETE Deletes an SNMP Manager IP address from the SNMP
Manager Table
Remarks: The length of read community string and write community string
are limited to 10 characters to satisfy TL1 requirements.
Related: USERS
Restrictions: None
Note: Except for the first built-in entry, Read community: ‘public’ and
Write community: ‘private’, all user added community strings are
capital cases. Maximum is five SNMP user entries which includes the
built-in user.
To Next Page
Loading...
Need help?
General
