Troubleshooting
Overview
170 TimeHub 5500 TL1 Reference Guide 097-55501-02 Issue 7 – January, 2005
Overview
Automatic messages automatically report network and system alarmed and
non-alarmed events. Events are conditions that are detected by the TimeHub 5500.
The alarm property of each event specifies how it is reported, or if it is not reported.
For certain events, this property is user configurable to control which automatic
messages are generated by the system.
Automatic Messages
Automatic messages are generated by the TimeHub 5500, saved in the automatic
output (AO) log, and sent to the communications port (and displayed if there is a
terminal connected to the port).
Automatic messages are listed as follows: After the message name, a definition of
the message is given. The definition is followed by the actual message, followed by
the variables displayed in the message.
User Logged Off
This message appears when a user logs off the system or when the user was
automatically logged off by another user. The message format is:
<sid> <date> <time>
A 0010 CANC
<user>
;
Alarm Event
This message reports an alarmed event. In general, an alarmed event causes a
standing condition and has immediate or potential impact on the operation or
performance of the TimeHub 5500. The message format is:
<sid> <date> <time>
<severity> 0014 REPT ALM TSG
"<aid>:<ntfcnde>,<event>,<svreff>,,,,\"<conddescr>\","
;
Parameter Value Description
<severity> ** Major alarm
* Minor alarm
*C Critical alarm
A Alarm cleared or no alarm
To Next Page
Loading...
Need help?
General
