Commands
Command Description
54 TimeHub 5500 TL1 Reference Guide 097-55501-02 Issue 7 – January, 2005
Command Example:
OPR-ACO-ALL:::SC001;
Reinstate User
This command reinstates a user who was previously inhibited from logging on (by
using the INH-USER-SECU command). The command format is:
ALW-USER-SECU:[<tid>]::<ctag>::<uid>;
Command Example:
ALW-USER-SECU:::SC001::FRED;
The command in this example reinstates the user (FRED) after he was inhibited
from logging on.
Retrieve Alarm Condition
This command displays alarm information. The command format is:
RTRV-ALM[-TSG]::[<aid>]:<ctag>;
Firmware version 4328D also supports the following command syntax:
RTRV-ALM-ALL:::<ctag>::,,,,,;
Parameter Value Description
<uid> Up to ten case-insensitive
alphanumeric characters
Assigned user name
Parameter Value Description
<aid> (Null) Displays all active alarms from the system
CLK Displays equipment related alarms from both Clock cards
and the Output cards, but only displays input signal related
alarms from the active Clock card
CLK1 Displays both equipment related and signal related alarms
from Clock card 1 if it is the active card or inactive card.
Alarms from other cards are not reported.
CLK2 Displays both equipment related and signal related alarms
from Clock card 2 if it is the active card or inactive card.
Alarms from other cards are not reported.
To Next Page
Loading...
Need help?
General
