Commands
Command Description
70 TimeHub 5500 TL1 Reference Guide 097-55501-02 Issue 7 – January, 2005
Response Format:
<sid> <date> <time>
M <ctag> COMPLD
;
Command Example:
RTRV-HDR:::SC1;
The command in this example displays system header information.
Response Example:
SYMMBITS 04-06-15 15:03:27
M SC1 COMPLD
;
Retrieve Log
This command displays all events in the event log. The event log is displayed in
reverse chronological order, last in, first out. Events placed in the log are those
which have their LOG property set to Y. It can include both alarmed and
non-alarmed events and events not initially reported (those with ALM property set to
NONE). Events are displayed in groups of ten. The command format is:
RTRV-LOG:[<tid>]:<aid>:<ctag>::<start retrieving messages>;
Parameter Value Description
<aid> CLK Displays all events from the active Clock card event log
CLK1 Displays all events from the Clock card 1 event log
CLK2 Displays all events from the Clock card 2 event log
<start retrieving
messages>
EVTTOP Displays the ten most recent events from the top of the event log
EVTCONT Continues to display the next ten log messages from where last left
off
EVTALL Displays the entire event log
Note: EVTALL displays the entire contents of the event log which can
hold up to 1000 events consisting of 100 response blocks of ten
events each. Once started, the retrieval cannot be aborted. Use
EVTTOP and EVTCONT to retrieve the event log.
To Next Page
Loading...
Need help?
General
