Commands
Command Description
32 TimeHub 5500 TL1 Reference Guide 097-55501-02 Issue 7 – January, 2005
Command Description
This section provides detailed descriptions of TL1 commands. Following each
command name is a definition, the command syntax, and a list of command
parameters, values, variables, and descriptions (see Table 2-1 for a list of command
parameters). An example of each command showing typical parameter entries and
an example of the response is also provided.
Activate Bulk Text Transfer Mode
This command instructs a Management card or Clock card to enter into bulk text
transfer mode prior to downloading segments of firmware. The command format is:
ACT-BTT:[<tid>]:<aid>:<ctag>;
Command Example:
ACT-BTT:SYMMBITS:CLK1:SC003;
Response Example:
SYMMBITS 04-06-15 05:01:26
M SC003 COMPLD
;
Activate Software Download Mode
This command places a Management card or Clock card in the firmware download
mode prior to a firmware download. The command format is:
ACT-SWDL:[<tid>]:<aid>:<ctag>;
Parameter Value Description
<aid> IMC Management card
CLK1 Clock card 1
CLK2 Clock card 2
Parameter Value Description
<aid> IMC Management card
CLK1 Clock card 1
CLK2 Clock card 2
To Next Page
Loading...
Need help?
General
