SYNAPTICON CIRCULO 7 - Page 337

The last step of the setup wizard will guide you through the offset detection. The procedure starts with a value
of 100% which should yield good results.
Note
When using a power supply that can’t provide the rated motor phase currents, set the slider to a lower
value. This may be indicated by the error “Undervoltage”.
Synapticon Documentation
© 2021 Synapticon GmbH | Daimlerstraße 26 | D-71101 Schönaich Documentation v 4.11.0 | Built 2021-07-23 337/887