Sysmex XP-300 7-23
Sample Analysis
January 2012
Entering from handheld bar code reader
After pressing the [Operator] display column, the bar code can be
read in the status of displaying the numerical keys dialog. If the
displayed sample ID is not correct, read the bar code again.
Make sure that the displayed operator ID is correct, and press the
[Ent.] button.
After the manual input is started, a bar code cannot be read. In this
case, press the [Ent.] button once, then press the [Operator] display
column again to read the bar code.
• When using a bar code label, affix it properly so it is
flat and smooth without creases or flares.
• A reading error may occur when a bar code reader is
used without a check digit. It is recommended to use
a check digit or to check the sample ID after entry.
For details about check digits, see “ID Bar code
specifications” in “14.4 Connecting the bar code
reader”.
• Do not use any other characters than alpha-
numerics, hyphens and space on the bar code label.
To Next Page
Loading...
