Bus setups Set up an Ethernet seria l bus
For information on the controls, click the buttons.
To use
To set the serial bus type, click the Serial Bus Type entry box and select from the drop-down list.
To select the standard, click the Standard and select the standard from the drop-down list.
To select the signal type, click the Signal Type and select the signal type from the drop-down list.
To change the input for a component, click the Input and select a channel from the cascading lists.
To change a voltage threshold level, click the Threshold entry box and use the keypad to enter a value
or use the multipurpose knobs to select a voltage level.
Behavior
The instrument uses the selected components and voltage threshold levels to decode the selected bus.
What do you want to do next?
Learn more about bus setups. (see page 95)
Learn about bus configuration. (see page 148)
Learn about digital setups. (see page 87)
Learn how to set up an I2C serial bus. (see page 582)
Learn how to set up an SPI serial bus. (see page 582)
Learn how to set up a USB serial bus. (see page 584)
LearnhowtosetupanRS-232serialbus. (see page 583)
Learn how to set up a MIPI DSI1 Serial Bus (see page 584)
Learn how to set up a MIPI CSI2 Serial Bus (see page 585)
Learn how to set up an 8B10B Serial Bus (see page 111)
Learn how to set up an Custom serial bus. (see page 586)
122 DSA/DPO70000D, MSO/DPO/DSA70000C, DPO7000C, and MSO/DPO5000 Series
To Next Page
Loading...
Need help?
General
