About Tektronix oscilloscopes Options
Record Length:
Opt. 2RL - 25 MSamples/ch, 50M maximum for 1 GHz and 2 GHz
Opt. 5RL - 50 MSamples/ch, 125M maximum for 1 GHz and 2 GHz
Opt. 10RL - 125 MSamples/ch, 250M maximum for 1 GHz and 2 GHz
DPO7000C
Hardware:
Opt. 2SR (available only on DPO7104C instruments) - D ouble maximum real time sample
rate
Record Length:
Opt. 2RL-125MSamplesmax,25MSamples/ch
Opt. 5RL-250MSamplesmax,50MSamples/ch
Opt. 10RL - 500 MSamples max, 125 MSamples/ch
Service:
Opt CA1 - Provides single calibration event for the designated interval
Opt. R3 - Repair service 3 years, including warranty
Opt. R5 - Repair service 5 years, including warranty
Software:
Opt. DDRA - DDR Memory Bus Analysis
Opt. ET3 - Ethernet Compliance Test
Opt. D-PHY - MIPI® D-PHY Characteri
zation and Compliance Testing
Opt. LSA - Low Speed Serial Analysis (CAN/LIN trigger)
Opt. LT - Waveform Limit Testing
Opt. MTM - Serial Communications Mask Testing
Opt. PWR - DPOPWR Power Measurement and Analysis
Opt. SR-AERO - MIL-STD-1553 Serial Triggering and Analysis
Opt. SVE - SignalVu™ Essentials for Vector Signal Analysis
Opt. SVM - General Purpose Modulation Analysis (requires SVE)
Opt. SVO - Flexible OFDM Analysis (requires SVE)
Opt. SVP - SignalVu Pulse — Advance Signal Analysis Software (requires SVE)
Opt. SVT - Settling Time Measurements such as Frequency and Phase (requires SVE)
Opt. USB - Universal Serial Bus USB2.0 Compliance Test
Opt. VET - Visual Trigger and Search
12 DSA/DPO70000D, MSO/DPO/DSA70000C, DPO7000C, and MSO/DPO5000 Series
To Next Page
Loading...
Need help?
General
