Woodward LS-5 v2 Series - Page 229

[A] Button group "Hardware"
No. Button Function (all screens)
1 Change into MANUAL operating mode. The LED indicates that the
operation mode is active.
When MANUAL is selected, breaker control is performed manually via the
buttons (No. 4 (CBA) and No. 6 (CBB)).
If the control unit is con󰈡gured to application mode
A05
(parameter
8992) the button has no function.
2 Change into AUTOMATIC operating mode. The LED indicates that the
operation mode is active.
When AUTOMATIC is selected, the control unit manages all breaker
control functions. These functions are performed in accordance with how
the control unit is con󰈡gured.
3 Perform lamp test.
[B] Button group "Display" (Softkeys)
No. Button Function (main screen) Function (other screens)
4 AUTOMATIC operating mode: No
function.
MANUAL operating mode: OPEN /
CLOSE breaker CBA according to
graphic icon on display.
The push button has only a
function if a graphic icon is
assigned.
5 Toggle between delta/wye voltage
display. The index of the "V"
symbol indicates whether delta or
wye voltage is displayed and which
phases are displayed.
Refer to ╚═▷ Tab. 28.
The push button has only a
function if a graphic icon is
assigned.
6 AUTOMATIC operating mode: No
function.
MANUAL operating mode: OPEN /
CLOSE breaker CBB according to
graphic icon on display.
The push button has only a
function if a graphic icon is
assigned.
7 The LED indicates that alarm messages are active/present in the control
unit.
[C] Button group "Navigation"
No. Button Function (main screen) Function (other screens)
8 Reset "Horn". Enter / Acknowledge
9 Display the "Alarm list" screen. Scroll up / Raise value
Display the "Main menu" screen. Scroll down / Lower value
229LS-5 v2 Series37650
5 Operation
5.2 Front Panel Access
Released