YASKAWA CIMR-G5A Series - Page 347

12.5 User Constants
12 - 19
No.
Name
(Display)
Factory
Setting
Setting No.
Name
(Display)
Factory
Setting
Setting
L8-03
Operation selection after overheat pre-alarm
(OH Pre-Alarm Sel)
3
o1-05
Constant no. display selection
(Address Display)
0
L8-05
Input open-phase protection selection
(Ph Loss In Sel)
0
o2-01
LOCAL/REMOTE key enable/disable
(Local/Remote Key)
1
L8-07
Output open-phase protection selection
(Ph Loss Out Sel)
0
o2-02
STOP key during control circuit terminal op-
eration
(Oper STOP Key)
1
L8-10
Ground protection selection
(Gnd Det Sel)
1
o2-03
User constant initial value
(User Defaults)
0
L8-17
Carrier frequency reduction selection
(L-Spd IGBT Prtct)
1
o2-04
kVA selection
(Inverter Model #)
0
:
2
L8-19
OL2 characteristics selection for low speeds
(OL2 Chara@ L-Spd)
0
o2-05
Frequency reference setting method
:
1
(Operator M.O.P.)
0
o1-01
Monitor selection
(Monitor Select)
6
o2-06
Operation selection when digital operator is
disconnected
(Oper Detection)
0
o1-02
Monitor selection after power up
(Power-On Monitor)
1
o2-07
Cumulative operation time setting
(Elapsed Time Set)
−
o1-03
Frequency units of reference setting/monitor
(Display Scaling)
0
o2-08
Cumulative operation time selection
(Elapsed Time Run)
0
o1-04
Frequency units of constant setting
(Display Units)
0
o2-09
Initialize mode selection
:
1
(Init Mode Sel)
0
:
4
* 1. Not displayed for some models depending on software version No.
* 2. Setting unit and initial setting depend on Inverter capacity.
* 3. Setting for 200 V class Inverters. For 400 V class Inverters, double the value.
* 4. Not initialized. (Japanese standard specification is o2-09 = 0.)
12