System Setup
9 - 187
9.17 Changing the parameter setting
The parameters are protected not to be changed easily.
The following operations are allowed only for the operator who can set the SECURITY
mode to the MANAGEMENT mode or higher.
The operations must be performed properly.
1. Select {PARAMETER} under the main menu.
2. Select the parameter type.
– The PARAMETER window appears. Select the desired parameter.
3. Move the cursor to the desired parameter number.
– When the desired parameter number is not in the current window, move the cursor in
the following way:
1) Move the cursor to a parameter number and press [SELECT].
2) Enter the desired parameter number with the numeric keys and press [ENTER].
3) Press [ENTER].
4) The cursor moves to the selected parameter number.
Binary Data
Decimal Data
1
2
To Next Page
Loading...
