System Backup
10 - 337
5. Select {CMOS}.
The confirmation dialog box appears.
6. Select {YES}.
Select {YES} to save the CMOS data into the SD card.
When saving the file, if the CMOS.BIN file already exists in the SD card, the following
confirmation dialog box appears.
7. Select {YES}.
The CMOS.BIN file is overwritten in the SD card.
NOTICE
When not using the data stored in the portable memory device, make sure to keep the
device under an appropriate management.
10.2.2 CMOS.BIN load
Follow the procedures below to load CMOS.BIN.
1. Turn ON the YRC1000 power supply while pressing [MAIN MENU].
2. Change the SECURITY mode to the MAINTENANCE mode or higher mode.
3. Insert a SD card into the SD card on the programming pendant.
When USB memory is used instead of SD card, mount USB memory and select “USB:
Pendant” or “USB1: Controller” in the {DEVICE}.
4. Select {EX. MEMORY} under the main menu.
The sub menu appears.
To Next Page
Loading...
