System Backup
10 - 333
10 System Backup
For the YRC1000, the system data can be collectively backed up in advance so that the
data can be immediately loaded and restored in case of an unexpected trouble such as data
loss.
10.1 System Backup with robot controller
For the YRC1000, four types of collective backup are available: CMOS.BIN and
CMOSBK.BIN.
10.1.1 Function types of data
10.1.1.1 CMOS.BIN
For the normal backup, use this data.
Save: Perform in the MAINTENANCE mode (the EDITING mode or higher).
Load: Perform in the MAINTENANCE mode (the MANAGEMENT mode).
As for the load/save procedures, refer to chapter 10.2 "Backup by CMOS.BIN" at page 336.
Target Area: All areas of the internally stored data (Note that the monitoring time is not
loaded).
10.1.1.2 CMOSBK.BIN
This data is used in the automatic backup function.
Save: Saves with the preset conditions in the normal mode.
Load: Perform for the system restoration in the MAINTENANCE mode (the MANAGEMENT
mode).
For details, refer to chapter 10.3 "Automatic Backup function" at page 338.
Target Area: All areas of the internally stored data (Note that the monitoring time is not
loaded).
To Next Page
Loading...
