System Setup
9 - 248
4. Enter the password if required.
Password recognition is set as follows in the factory:
SAFETY MODE: [5555555555555555]
5. Press [ENTER].
When the entered password is correct, the mode is changed to {SAFETY MODE}
.After changing to the safety mode, the icon on the status area is changed to .
NOTICE
For the key pad of the numerical input, display (available) and hide (non-available) can be
switched by selecting the “SETTING OF WINDOW” in the main menu shown on the
programming pendant.
At factory setting, the key pad is set as display (available).
9.26.3 Available I/O signals and instructions in safety logic circuit
The following is the explanation of the input and output signals and logic (instructions)
available in the safety logic circuit.
Logic
No. Display Contents Note
1 NOT Negative (reverse of signal)
2 DSU Detection of signal rising edge
1
To Next Page
Loading...
