System Backup
10 - 338
5. Select {LOAD}.
The load display appears.
The items marked with “■” cannot be selected.
6. Select {CMOS}.
The confirmation dialog box appears.
7. Select {YES}.
The loaded CMOS.BIN file contents are reflected in the data inside the robot.
NOTICE
When the “CMOS load” is performed, the current CMOS data is replaced with the CMOS
data (the contents of “CMOS.BIN”) in the selected device. Therefore, before performing the
load, make sure to perform the “CMOS Save” of the CMOS data to be loaded.
10.3 Automatic Backup function
10.3.1 Objective
With the automatic backup function, the data saved in the YRC1000 such as system setting
or operational condition are collectively backed up in the SD card, which is stored in the
programming pendant, or the selected device at the automatic backup window.
Able to back up to the following devices.
• The SD card of the programming pendant
• The SD card of the ACP01 board
• The RAM AREA of the ACP01 board (It will display, when the high speed Ethernet
server function is effective.
NOTICE
The automatic backup function is enabled only while the YRC1000 power supply is ON
whereas it isn’t while in the maintenance mode or the power supply is OFF.
To Next Page
Loading...
