System Setup
9 - 209
2. Select {PM(REDUCER)}.
– The lifetime calculation window is appears. In case of the another window appears,
select {Display}, and select the {=LIFE CALCULATION} in the pull down menu to
display the lifetime calculation window.
Each item on the screen represents the following description.
• Invalidate the replacement signal and the message display
Able to invalidate the replacement signal and the message display in each axis. Invalidate
the replacement signal and the message display by the following procedures, in case of the
speed reducer seems to operate normally even though the replacement signal is turned
ON.
1. Change the security mode to the management mode.
2. Select {=PM} in the main menu.
= TIME TO REPLACEMENT
Displays the rest of the lifetime to replace the speed reducer. The calculation of the
subtraction of the number is operated automatically by performing the JOB in the play
mode.
= NOTICE TIME
By setting the time in this section, the replacement time is informed by displaying the
message and turning the replacement signal ON before the “TIME TO REPLACE-
MENT” becomes “0”.
For example, when set with “100”, the message will be displayed 100 hours before the
“TIME TO REPLACEMENT” becomes “0”, and the replacement signal will be turned
ON as well.
For example, when set with “-100”, the message will be displayed 100 hours after the
“TIME TO REPLACEMENT” became “0”, and the replacement signal will be turned ON
as well.
= WARNING
Select this item to invalidate the notification signal and displaying the message. [Inval-
id] and [Valid] will alternate each time when press the [Select].
= RESET
Select this item after replacing the speed reducer. Addition to the message is deleted,
and the replacement signal is OFF, “TIME TO REPLACEMENT” is reset.
1
2
3
4
To Next Page
Loading...
