System Setup
9 - 265
3. In the following setting, SFBOUT01 to SFBOUT04 are available in the safety logic
circuit and SFBOUT05 to SFBOUT08 are available in the functional safety function.
After changing the setting, the status in the title line becomes “NOT DONE” and
{WRITE} menu is shown. Update the data.
4. When the data update is completed, the status in the title line becomes “DONE” and the
{WRITE} menu disappears.
5. When either “NOT USED” or “FUNCTIONAL SAFETY” is set, the output signal in the
safety logic circuit is not available.
6. The display of input and output signal used in the safety field bust function can be
switched by {SIGNAL CHG}.
To Next Page
Loading...
