System Setup
9 - 327
3. Select {SETTING} of {DISPLAY} in the pull down menu.
The USER GROUP OUTPUT SETTING window is shown.
4. The user group output is set.
START
Specify the first number of the general purpose output signal to be allocated.
LENGTH
Specify the number of the signals which is allocated to one group (1 to 32).
When the parity check is specified, the parity bit is the highest bit.
When the length is 1, the parity check cannot be specified.
PARITY
Specify the parity check.NONE: Parity check is not specified
ODD: Odd parity is specified
EVEN: Even parity is specified
NAME
The group signal name is set.
1
2
3
4
To Next Page
Loading...
