Ascotel IntelliGate 2025/2045/2065
234 Routing elements Part 2
Fig. 2.41: Switching groups and how their changeover switches are used
The choice of switch group and the assignment of the switch positions are carried
out in the appropriate menus of the system configuration. After initialization the
changeover switches are allocated throughout to switching group 1.
Switching groups are selected via menu selection or by dialling */# procedures on
a terminal (see "Switching switch groups", page 535). The relevant authorization
can be regulated individually for each internal subscriber. ("Changeover authori-
zation" setting). Digit barrings can also be used to limit changeover authorizations
to individual switching groups.
Switching group 1 can also be selected via the ports of the control inputs (see
"Switch group interface", page 813). Selection via the control inputs takes prec-
edence over selection via */# procedures. This means that the */# procedure can-
not be executed as long as a signal is imposed at the control inputs.
9
Internal and PISN-internal destinations
Courtesy groups
Internal and external barred-code checks
Internal barred-code checks
Internal, PISN-internal or external destinations
Internal destinations
Incoming calls
Incoming calls
Outgoing calls
Internal calls
Emergency calls
Switching groups
Door bell
1
2
haz0716aaena0
To Next Page
Loading...
