Ascotel IntelliGate 2025/2045/2065
460 Features Part 2
8.3.2 Hold (enquiry call)
An A – B connection is put on hold if one of the callers, e.g. subscriber B wants
to set up an enquiry call connection with C.
Fig. 2.173: Putting a call on hold
Detailed Description
Tab. 2.156: Hold (enquiry call)
If A is on hold and B hangs up before setting up a ringing or call connection to C,
B's terminal will ring continuously for 10 seconds. As soon as B picks up the hand-
set, he is again connection with A.
If A is on hold and B waits for more than 10 seconds before setting up a ringing
or call connection to C, B will obtain the busy tone. The return to the initial con-
nection is not automatic.
Suffix dialling procedures
Tab. 2.157: Hold (enquiry call): Procedures
Interface Operating sequence / signalling on the terminal Scope
A "Music on hold" is played to subscriber A, who
is on hold
1)
1)
With hold in the public exchange, the signalling depends on the network provider.
Possible interfaces:
internal, external, PISN
C Possible interfaces:
internal, external, PISN
System Terminals a/b terminal
Set up internal enquiry call with or without call preparation R SC No. (R = control key)
Setting up an inquiry call to a subscriber
of the up-circuit PBX (condition: the
user's own PBX is in an analogue down-
circuit connection and the existing call
connection already seizes a trunk line to
the up-circuit PBX)
via function key with control key
function (macro ".*42")
R*42 SC No.
A B
C
haz0589aaxxa0
To Next Page
Loading...
