Ascotel IntelliGate 2025/2045/2065
684 Planning a private network Part 3
6.2.1.2 Defining the routes to the public network
In each system create a route to the public network. The simplest way is to reserve
one route number for the public network.
System 1 is the gateway PINX, i.e. all the calls between the private leased-line net-
work and the public network are routed via this system. The route that assumes
this task must be specified.
1. Reserve route 1 for the public network.
2. In each system create the route to the public network:
– System 1: Route 1 (route 1-1)
– System 2: Route 1 (route 2-1)
– System 3: Route 1 (route 3-1)
3. In all the systems, specify route 1 as "to the public network".
4. In system 1 specify route 1 for routing calls from other systems to the public
network:
– Transit route = route 1
6.2.2 Creating the trunk groups
6.2.2.1 Creating the trunk groups between the systems
Create a trunk group with all the lines between two systems.
1. In system 1 create a trunk group with all the lines to system 2 (trunk group 1-
4) and a trunk group with all the lines to system 3 (trunk group 1-5).
2. In system 2 create a trunk group with all the lines to system 1 (trunk group 2-
4). As there are no lines leading directly to system 3 and there are no other
lines, you do not need to create any other trunk groups.
3. In system 3 create a trunk group with all the lines to system 1 (trunk group 3-
4).
To Next Page
Loading...
