Aastra Ascotel IntelliGate 2025 - 8.1.1 Office10

Ascotel IntelliGate 2025/2045/2065
818 Installing terminals Part 4
Terminal selection
Two Office system terminals can be connected to an AD2 interface. The PBX can
only differentiate the two terminals by the position of the address switch on the
terminal. The following settings are possible:
• TSD1
• TSD2
Type of set
The set type (feature phone or key phone)is determined by during the configura-
tion of the installation, when the lines are also assigned to the line keys.
8.1.1 Office 10
The system terminal is a desktop model. A wall-mounted bracket is available as
an option.
Installation of the desktop model
1. Feed the connecting cable through the strain relief on the handset rest.
2. Position the handset rest as required and put the handset in place.
Installation of the wall-mounted bracket (Option)
1. Feed the connecting cable through the strain relief on the wall-mounted
bracket.
2. Screw the wall-mounted bracket onto the wall using the screws supplied and
hook the handset into position.
Connection
1. Set the AD2 bus address (Fig. 4.81).
2. Plug the connector into the socket-outlet.
3. To register the terminal: Press the Foxkey twice.
The acknowledgement tone is heard.
4. If the system is configured, test the operation of the terminal.
5. Label the telephone.