Ascotel IntelliGate 2025/2045/2065
Part 7 Hardware updates and system expansion 903
Remove EIM card
1. Remove the PBX housing cover.
2. Touch the earthed housing (equipotential bonding).
3. Open the chip-card housing (slide the lock toward ”Open”).
4. Remove EIM card.
Fit the EIM card
1. Fit a new EIM card.
2. Close the chip-card housing (slide the lock toward ”LOCK”).
3. Press the Prog. pushbutton (see Fig. 7.1 and Fig. 7.2).
4. Mounting the PBX housing cover.
5. After the system has started, log on all DECT handsets again. This is necessary
because the DECT identification numbers are stored on the EIM card.
Note:
The EIM card must be fitted before the system is put into operation. The
PBX will not start without the EIM card.
3.2 Expansion cards
Basic systems are expanded by equipping the expansion slots with expansion
cards. This chapter describes how and when expansion cards are expanded,
moved and replaced.
The combination of card type and the the maxium expansion is determined by sys-
tem limits. The system and expansion limits of the various basic systems are
described in "Licence-related System and Expansion Limits", page 593.
Expansion card types
There are three types of expansion cards: Subscriber cards, trunk cards and special
cards. An overview of the different cards with their interfaces can be found in
"Equipping the PBX", page 733.
To Next Page
Loading...
