Ascotel IntelliGate 2025/2045/2065
Part 3 Planning a PBX 607
Example: Enquiry call behind PBX
This feature is described in Part 2 under "Hold (enquiry call)", page 460. It can be
used from both analogue terminals and system terminals.
Fig. 3.8: Enquiry call behind PBX
Procedures with different terminals
Situation: The existing call connection of an Ascotel subscriber already seizes a
trunk line to the up-circuit PBX. The procedure for setting up an inquiry call
depends on the type of terminal:
• Analogue terminal
– Flash: Dial tone of Ascotel
– Flash *42: Dial of up-circuit PBX
• OfficeTerminals
– Enquiry call menu: Dial tone of Ascotel
– Key with macro ".*42": Dial of up-circuit PBX
Using the exchange's features
To activate features on the public network such as the exchange feature "Call For-
warding" from the system itself, you need to seize a trunk line. The feature can
then be entered in accordance with the service provider's operating instructions.
See also:
System configuration:
– Down-circuit from the PBX; Analogue network interfaces
– Dialling type; Analogue network interfaces
a/b
AD2
S bus
AscotelPBX
haz0825aaena0
To Next Page
Loading...
