Aastra Ascotel IntelliGate 2025 - Page 842

Ascotel IntelliGate 2025/2045/2065
842 AIMS configuration tool Part 5
Note:
The following settings apply to all Windows versions. The procedure
may vary from one Windows version to the next. More detailed instruc-
tions can be found in the Operating Instructions "Setting up the PC-PBX
connection". They are stored in AIMS in the Information Manager.
LAN configuration
The LAN access configuration (e.g. the PC-IP address) depends on the local net-
work. The relevant instructions can be found in the Connection Operating Instruc-
tions.
Modem configuration
The following modem configuration has to be carried out for internal and external
access via an ISDN card or ISDN Terminal Adapter or for access via Pocket Adapter
or V.24 interface:
1. Install a modem with modem driver for PPP connection.
– For Pocket Adapter PA or V.24 interface use the driver "Ascotel Direct PPP
Connection".
1)
– For ISDN TA and ISDN cards, use the manufacturer's drivers.
2. Set the other parameters (depending on the Windows version):
– Select the COM port for connection to the PC
– Max. speed (V.24 interface): 115200 (initialization: 9600)
– Max. speed (via Pocket Adapter): 19200 (initialization: 9600)
– Max. speed (via Terminal Adapter): depends on the manufacturer
– Activate hardware flow control
Setting Up dial-up networking for local access
The following configuration is required for local access:
1. Create a new dial-up connection (e.g. "Ascotel local").
2. Select the "Ascotel Direct PPP Connection" modem.
3. Select client protocol "TCP / IP".
4. Set the other parameters (depending on the Windows version):
– Deactivate software decompression.
– Deactivate LCP expansion
1)
The driver can be obtained on the Ascotel home page https://pbxweb.aastra.com and in the AIMS installa-
tion path.