Aastra Ascotel IntelliGate 2025 - Page 856

Ascotel IntelliGate 2025/2045/2065
856 Configuration Steps Part 5
6. Set up the direct dialling plans, DDI numbers and call distribution elements
(see "Direct Dialling Plan (DDI plan)", page 223 and "Call Distribution Ele-
ment (CDE)", page 226).
A call distribution element is automatically allocated to each DDI number cre-
ated.
You can also define ranges for DDI numbers. If so, the question is whether
only the DDI numbers that match the internal subscribers are to be created
(see "Call Routing", page 267).
7. Edit the direct dialling plans and call distribution elements:
– If required, adapt the allocation of call distribution elements to the DDI
numbers in the direct dialling plan menu.
– If necessary, use the Call Distribution Elements menu to adapt the destina-
tions in accordance with the switch groups.
8. Create other direct dialling plans and call distribution elements and define
them for internal subscribers and internal PISN subscribers. Define the desti-
nations in accordance with the switch groups. Complement the numbering
plans accordingly.
Network-oriented routing elements
9. Define the network interface (see "Point-to-Point and Point-to-Multipoint
Connections", page 62 and "Trunk Groups of Network Interfaces", page
213).
– S external to other PINXs
– Point-to-point connections (TEI management)
– Point-to-multipoint connections (TEI management)
– Collision detection for terminals connected in parallel
– Assign the network interfaces to the trunk groups
10. Define the digital trunk groups (see "Trunk groups", page 212)
–Name
– Allocate the direct dialling plan (possibly call distribution element only)
– Allocate the call distribution element (possibly direct dialling plan only)
– CLIP information (TON / NPI)
– DSS1 / PSS1 protocol
– Private / public
– Other settings as required
11. Define the analogue trunk groups (see "Trunk groups", page 212)
–Name
– Allocate the call distribution element