Aastra Ascotel IntelliGate 2025 - Page 915

Ascotel IntelliGate 2025/2045/2065
Part 7 Operations supervision 915
Numbers missing Card(s) not full logged on
• Insufficient memory reserved in the num-
bering plan to enable allocation of num-
bers to all subscribers: Type in missing
numbers by hand
Date, time
Outgoing call rejected Call rejected by the network
• On any line: error code 34
• On required line group:
error code 44
Port number of the exchange
line circuit, cause, date, time
PBX power supply: Battery • Warning when the UPS takes over the
power supply to the PBX.
(Battery parameter)
• All-clear once the 230 V mains power
supply is restored.
(Parameter: Mains power)
0: Battery / 1: Mains power,
date, time
Port out of service A port previously in operation has stopped
functioning.
Number of the expansion slot,
relevant port number, date, time
QSIG licence limit reached Maximum number of licensed outgoing
connections with QSIG protocol exceeded
Route number, subscriber
number, date, time
Recording error • Card not fitted
• Card not logged on
• Card defective
Card number, date, time
Remote maintenance is
activated
Remote maintenance has been activated Unfiltered output to local desti-
nations
Reset card A reset was carried out for one card Number of the expansion slot,
date, time
Software upload During an upload in PBX status:
• "Updating…"
• "Monitoring…"
• "Normal operation"
• "New PBX software loaded,
starting..."
• "New PBX software crashed,
rollback executed"
• "New PBX software started,
running fault-free"
Date, time
Subscriber does not answer No answer to incoming DDI call from dig-
ital subscriber on S bus or AD2
DDI No., date, time
Synchronisation loss to
exchange
A T / T2 interface entered in the clock pool
has lost the system clock.
Port number, date, time
System overload Network access attempted when all lines
are seized or the PBX is overloaded.
Route number, subscriber
number, date, time
Terminal power supply:
Overload
Rated power slightly exceeded for > 4 sec-
onds
Date, time
Terminal power supply:
Switch Off
Rated power clearly exceeded for > 4 sec-
onds
Date, time
The System has crashed The System has crashed Date, time
Event / error message Trigger condition Details